Shaft adapter for Fanatec Direct Drive Wheel Base

Based on this (1) DD1 Nrg Quick release mod : Fanatec (reddit.com) project by Ramsey Connely I have been able to put the product into production with Ransey's full backing.

This product will allow you to fit a different Quick Release system to a Fanatec DD1 / DD2 wheelbase 

(DOES NOT FIT CSL or CSW Wheelbases)

What you get in the kit

• Aluminum shaft adapter - to clamp to the Podium shaft and give 6 x 70mm hole pattern mounting for any matching fitting.
• SRM Emulator PCB to make the wheelbase think a Fanatec Formula Carbon wheel is attached and therefore enable force feedback.
• Adapter cable from the 2 x 6 pin plugs in the Podium wheelbase to the SRM Emulator PCB

The SRM Emulator have the button and shifter connections removed as standard to reduce height.  If you use one of my spacers between this part and your Quick Release, then you can choose the fully populated emulator

Fitting the cable:

• Fit the cable with White / Black / Green wires to the plug with black wires
• Fit the cable with Red wire to the plug with the Red wires